75 degrees - another beautiful day working on the cemetery, but first...
“Once upon a midnight dreary, while I pondered, weak and weary,
Over many a quaint and curious volume of forgotten lore,
While I nodded, nearly napping, suddenly there came a tapping,
As of some one gently rapping, rapping at my chamber door.
Tis some visitor," I muttered, "tapping at my chamber door —
Only this, and nothing more." -- E. A. Poe
I opened the garage door early this morning and immediately noticed that a raven came calling. Actually, it is a crow but still an omen of things to come.
 |
| Tap, tap...who's there? Mr. Raven's cousin the crow. |

Fast forward - later in the day the girls got off the bus and I began telling them that something really bad happened today. I was attacked by an animal. Of course they asked what happened and then I told them my Daddy truth - a raven come down from the sky and attacked me. They quickly said that they don't believe me. I then explained that I gave it a kick like in the Karate Kid movie and showed that bird who was more evolved. They then said - sure...where is the raven. I said it was over there in the trash and they went to go look. They were amazed!
Okay back to mortal earth. I printed a Fleur de Lis symbol that I found on the internet and enlarged it to a size that would be nice as a form in the center of the pillars. The paper was glued to a piece of Russian Baltic birch plywood and I cut the pieces out on the band saw while listening to Fleetwood Mac with my hearing protection on.
 |
| Sanding after much time at the band saw. |
 |
| Ready to go on the pillars. |
I then glued and nailed the symbols onto the pillars, wiped the excess glue off and primed them with the white paint.
The next step in the instructions was to prepare the balusters, which had to be cut to length on both ends and ripped in half. I created a jig to hold the pieces in my large cross cut sled that I built several years ago from wood that was found after a hurricane. It took a little while to rip all of them because I had to stop the saw each time one was cut so that I could reset the sled and place a new baluster into the jig.
 |
| First the ends were cut to length and a point was created at the bottom. |
 |
| Ripped in half down the middle. |
 |
| A look at the jig in the sled. |
 |
| Placing a fresh baluster in the jig. |
A long board was then ripped into long pieces that are somewhat square similar to the dimensions of real iron fence material and then I did a little math to determine the placement of the balusters across these long strips of wood. Two pieces were nailed at the bottom and one at the top to finish off a section of fencing.
 |
| Now you can see how much work this was but it is an important part of the cemetery fence. |
The pillars and fencing was setup for the moment so that I can see how it is going to look. The top fence run was attached to the pillars with an "L" bracket that can be easily removed for storage later.